Wang Libo*,Luo Zhiqiang,Jin Shengran.Study on surface rocessing and properties of high strength mechanical bearings[J].Plating & Finishing,2023,(7):17-25.[doi:10.3969/j.issn.1001-3849.2023.07.003]
高强机械轴承的表面加工与性能研究
- Title:
- Study on surface rocessing and properties of high strength mechanical bearings
- Keywords:
- bearing steel ; cryogenic treatment ; laser shock strengthening ; structure ; wear resistance
- 分类号:
- TG174.44
- 文献标志码:
- A
- 摘要:
- 针对机械轴承在复杂服役环境下出现局部磨损、疲劳开裂和腐蚀等问题，对 GCr15SiMn 轴承钢进行了深冷处理和激光冲击强化处理，研究了深冷处理时间、激光冲击强化次数和深冷 - 激光冲击复合强化对轴承钢显微组织、力学性能和耐磨性能的影响。结果表明：未处理和激光冲击强化后轴承钢试样都主要由马氏体和奥氏体组成；随着激光冲击强化次数增加，轴承钢的平均晶粒尺寸先增加后减小，在激光冲击强化 3 次时取得最小值；深冷处理和激光冲击强化都有助于降低轴承钢中残余奥氏体含量，且深冷处理时间越长残余奥氏体含量越低，深冷处理 8 h 时轴承钢中残余奥氏体含量为 0.81% 。深冷处理和激光冲击强化处理都有助于提高轴承钢的纳米硬度、弹性模量，降低磨损失重，且深冷处理 8 h 和激光冲击强化 3 次时，轴承钢的纳米硬度和弹性模量最大、磨损失重最小，这主要与此时轴承钢中晶粒尺寸较小、碳化物尺寸细小且均匀等有关。
- Abstract:
- ： Aiming at the problems of local wear ， fatigue cracking and corrosion of mechanical bearings in complex service environment ， GCr15SiMn bearing steel was subjected to cryogenic treatment and laser shock strengthening treatment ， and the effects of cryogenic treatment time ， laser shock strengthening times and cryogenic laser shock composite strengthening on the microstructure ， mechanical properties and wear resistance of bearing steel were studied. The results showed that ， both untreated and laser shock strengthened bearing steel samples are mainly composed of martensite and austenite. With the increase of laser shock strengthening times ， the average grain size of bearing steel increases first and then decreases ， and the minimum value is obtained when the laser shock strengthening times is 3. Both cryogenic treatment and laser shock strengthening can reduce the content of retained austenite in bearing steel ， the longer the cryogenic treatment time ， the lower the content of retained austenite ， and the content of retained austenite in bearing steel is 0.81% when the cryogenic treatment is 8 h. Both cryogenic treatment and laser shock strengthening treatment help improve the nano-hardness ， elastic modulus of bearing steel ， and wear loss was reduced. When cryogenic treatment is 8 h and laser shock strengthening is performed for 3 times ， the nano-hardness and elastic modulus of bearing steel are the largest ， and the wear loss is the smallest ， which is mainly related to the smaller grain size ， or the smaller and uniform carbide size in the bearing steel.
参考文献/References:
[1] 朱祖昌 , 杨弋涛 , 朱闻炜 . 第一、二、三代轴承钢及其热处理技术的研究进展 ( 十八 )[J]. 热处理技术与装备 , 2022, 43(2): 63-70.
[2] 郑凯 , 曹文全 , 俞峰 , 等 . 高温不锈渗碳轴承钢的研发现状与进展 [J]. 钢铁 , 2022, 57(7): 125-136.
[3] 高春月 , 郭武明 , 王海新 , 等 . 8Cr4Mo4V 钢表面减摩耐蚀涂层研究 [J]. 材料保护 , 2021, 54(9): 20-24.
[4] 周丽娜 , 杨晓峰 , 刘明 , 等 . 8Cr4Mo4V 高温轴承钢热处理及表面改性技术的研究进展 [J]. 轴承 , 2021, 8: 1-10.
[5] 张群莉 , 黄华 , 唐泽浩 , 等 . 42CrMo 钢激光 - 感应复合淬火滚动磨损与疲劳损伤行为研究 [J]. 中国激光 , 2022, 49(8): 250-261.
[6] 尹嵩 , 陆海峰 , 潘晨阳 , 等 . 面向轴件应用的激光熔覆修复强化试验研究 [J]. 材料保护 , 2021, 54(2): 86-92.
[7] Anusha E, Kumar A, Shariff S M. Diode laser surface treatment of bearing steel for improved sliding wear performance[J]. Optik, 2020, 206: 163357-163364.
[8] Kam M, Saruhan H. Vibration damping capacity of deep cryogenic treated AISI 4140 steel shaft supported by rolling element bearings[J]. Materials Testing, 2021, 63(8): 742-747.
[9] Cao Y P, Wang Z M, Shi W D, et al. Formation mechanism and weights analysis of residual stress holes in E690 high-strength steel by laser shock peening[J]. Coatings, 2022, 12(2): 285-285.
[10] Chen X, Song M, Liu T, et al. Effect of cryogenic-tempering treatment on the performance of high Ni gear steel[J]. IOP Conference Series Materials Science and Engineering, 2020, 892: 12015-12023.
[11] Li S, Xiao M, Ye G, et al. Effects of deep cryogenic treatment on microstructural evolution and alloy phases precipitation of a new low carbon martensitic stainless bearing steel during aging[J]. Materials Science and Engineering A, 2018, 732(8): 167-177.
[12] Song M K, Kim J D, Lee M Y. Improvement of surface characteristics of mold steel using laser cladding and shock peening[J]. Modern Physics Letters B, 2022, 36(18): 2037-2046 .
[13] Li D H, He W C, Zhang X, et al. Effects of traditional heat treatment and a novel deep cryogenic treatment on microstructure and mechanical properties of low-carbon high-alloy martensitic bearing steel[J]. Journal of Iron and Steel Research International, 2021, 28(3): 370-382.
[14] Yang Y, Lian X, Zhou K, et al. Effects of laser shock peening on microstructures and properties of 2195 Al-Li alloy[J]. Journal of Alloys and Compounds, 2018, 781: 330-336.
[15] 易超 , 黄巍 , 靳广虎 , 等 . Ni-PTFE 复合镀层的制备及其摩擦学性能研究 [J]. 电镀与精饰 , 2022, 44(7): 1-7.
[16] 崔通 , 贺甜甜 , 杜三明 , 等 . 激光冲击强化对 GCr15 轴承钢微观组织和摩擦学行为的影响 [J]. 表面技术 , 2022, 51(7): 353-362.
[17] Zhou G, Deng S, Wei W, et al. Effect of multiple deep cryo-treating and tempering on microstructure and property evolution of high carbon bearing steel[J]. Materials Research Express, 2020, 7(6):66529-66538.
[18] Satish K, Mohan N, Keshaorao K N, et al. Influence of deep cryogenic treatment on dry sliding wear behaviour of AISI D3 die steel[J]. Materials Research Express, 2018, 11(5): 116525-116534.
[19] Li C S, Li B Z, Jin X , et al. Microstructure and mechanical properties in core of a carburizing 20CrNi2MoV bearing steel subjected to cryogenic treatment[J]. Journal of Iron and Steel Research International, 2021, 28(3): 360-369.
[20] 孔丹 , 罗志强 , 金胜然 . 铜合金的表面化学镀层制备与摩擦学性能研究 [J]. 电镀与精饰 , 2022, 44(8): 23-30.
备注/Memo
收稿日期： 2022-09-01 修回日期： 2022-09-15 作者简介： 著者简介：王丽博（ 1984 ―）， 女，硕士， 副教授， email ： 18203690695@139.com 基金项目： 郑州市科技攻关项目（ 173SGZG23115 ），中国博士后基金项目（ 20171520986 ）?/html>