JI Haofei*,LIU Huiling.Hard Anodizing of 7A05 Aluminum Alloy Used for Manufacture of Roller in Mixed Acid Electrolyte and Its Performance[J].Plating & Finishing,2022,(9):86-92.[doi:10.3969/j.issn.1001-3849.2022.09.015]
滚轮用7A05铝合金混合酸硬质阳极氧化及性能研究?/div>
- Title:
- Hard Anodizing of 7A05 Aluminum Alloy Used for Manufacture of Roller in Mixed Acid Electrolyte and Its Performance
- Keywords:
- hard anodizing ; mixed acid electrolyte ; mass concentration of tartaric acid ; 7A05 aluminum alloy ; wear resistance ; corrosion resistance
- 分类号:
- TQ153.6
- 文献标志码:
- A
- 摘要:
- 为提高制造滚轮常用 7A05 铝合金的表面性能从而更好的满足服役条件，采用纯硫酸和酒石酸配制混合酸电解液对 7A05 铝合金进行硬质阳极氧化，并研究混合酸电解液中酒石酸质量浓度变化对阳极氧化膜的形貌、物相、硬度、耐磨性能和耐腐蚀性能的影响。结果表明：酒石酸质量浓度变化对阳极氧化膜的平整度、致密性、硬度、耐磨性能和耐腐蚀性能都有较大影响，而对物相无影响。当酒石酸质量浓度为 50 g/L 时，阳极氧化膜较平整致密，表面粗糙度仅为 0.462 μ m ，硬度较 7A05 铝合金提高近 2.4 倍，磨损率约为 7A05 铝合金的 1/3 ，腐蚀电流密度相比于 7A05 铝合金降低了近两个数量级，表现出优良的耐磨性能和耐腐蚀性能。适当增加酒石酸质量浓度使电解液对阳极氧化膜的腐蚀溶解程度减轻，同时能缓解高电压下释放出很多热量对阳极氧化膜造成的烧蚀程度，促使形成较致密的阳极氧化膜，其承载能力和抵抗塑性变形能力增强，并且电化学腐蚀阻力明显增加，有效的延缓腐蚀发展。
- Abstract:
- ： In order to improve the surface properties of 7A05 aluminum alloy commonly used for the manufacture of roller ， hard anodizing of 7A05 aluminum alloy was conducted in a mixed acid electrolyte prepared by pure sulfuric acid and tartaric acid to ensure that 7A05 aluminum alloy can better meet the conditions of service. The influence of tartaric acid mass concentration in the mixed acid electrolyte on the morphology ， phase ， hardness ， wear resistance and corrosion resistance of anodic oxide film was studied. The results show that the variation of tartaric acid mass concentration has obvious influence on the flatness ， compactness ， hardness ， wear resistance and corrosion resistance of anodic oxide film ， while it has no influence on the phase of anodic oxide film. When the mass concentration of tartaric acid is 50 g/L ， the anodic oxide film is smooth and compact ， and the surface roughness is only 0.462 μ m. The hardness is nearly 2.4 times higher than that of 7A05 aluminum alloy and the wear rate is about 1/3 of that of 7A05 aluminum alloy. The corrosion current density is nearly two orders of magnitude lower than that of 7A05 aluminum alloy ， and shows excellent wear resistance and corrosion resistance. Appropriately increasing the tartaric acid mass concentration can reduce the corrosion and dissolution degree of the electrolyte on the anodic oxide film ， and relieve the ablation degree of the anodic oxide film caused by the release of much heat under high voltage ， thus promote the formation of a denser anodic oxide film. The bearing capacity and plastic deformation resistance of the anodic oxide film are enhanced ， and the electrochemical corrosion resistance is significantly increased ， which effectively delays the development of corrosion.
参考文献/References:
[1] 陈东高 , 刘宏伟 , 谭兵 , 等 . 中厚度 7A05 铝合金 MIG 焊接工艺研究 [J]. 兵器材料科学与工程 , 2009, 32(6): 55-57.
[2] 周艳丽 . 5052 铝合金草酸阳极氧化和铬酸阳极氧化工艺研究 [J]. 电镀与精饰 , 2021, 43(2): 34-37.
[3] Zang J, Yu S R, Zhu G, et al. Fabrication of superhydrophobic surface on aluminum alloy 6061 by a facile and effective anodic oxidation method[J]. Surface and Coatings Technology, 2019 (380): 125078.
[4] Zhang Y G, Chen Y L, Bian G X, et al. Electrochemical behavior and corrosion mechanism of anodized 7B04 aluminum alloy in acid NaCl environments[J]. Journal of Alloys and Compounds, 2021 (886): 161231.
[5] 高崇 , 江钟宇 , 赵丕植 , 等 . 电流密度对 5252 铝合金阳极氧化膜性能的影响 [J]. 电镀与环保 , 2020, 40(3): 63-66.
[6] 彭蓉 , 杨武霖 , 符立才 , 等 . 低孔隙率阳极氧化铝膜的制备及其高绝缘特性 [J]. 中国有色金属学报 , 2018, 28(5): 964-970.
[7] 赵刚 , 张伟华 , 赵铭涛 . 氧化铈颗粒对铝合金阳极氧化膜性能的影响 [J]. 兵器材料科学与工程 , 2022, 45(3): 14-19.
[8] 刘君 , 龚利华 , 潘峰 , 等 . 6061 铝合金酒石酸 - 硫酸阳极氧化工艺研究 [J]. 材料保护 , 2021, 54(3): 94-99.
[9] Cheng Y L, Xie H J, Cao J H, et al. Effect of NaOH on plasma electrolytic oxidation of A356 aluminium alloy in moderately concentrated aluminate electrolyte[J]. Transactions of Nonferrous Metals Society of China, 2021, 31(12): 3677-3690.
[10] 安思宇 , 吕威 , 李雪松 . 硫酸电解液中铝合金硬质阳极氧化膜的表面形貌及性能研究 [J]. 电镀与环保 , 2020, 40(3): 50-52.
[11] Rueda F C G, González J T. Electrochemical polymerization of polypyrrole coatings on hard-anodized coatings of the aluminum alloy 2024-T3[J]. Electrochimica Acta, 2020, 347: 136272.
[12] 常帅 , 孙鑫 , 马林 , 等 . 基于单因素实验法的硬质阳极氧化膜制备及性能研究 [J]. 化学与粘合 , 2020, 42(5): 330-333.
[13] Santecchia E, Cabibbo M, Hamouda A M S, et al. Dry sliding tribological properties of a hard anodized AA6082 aluminum al loy[J]. Metals, 2020, 10(2): 207.
[14] 何潘亮 , 沈士泰 , 卫国英 . 硫酸 - 有机酸混合酸体系中铝合金硬质阳极氧化膜的研究 [J]. 电镀与环保 , 2017, 37(6): 25-28.
[15] 穆耀钊 , 叶芳霞 , 戴君 , 等 . 微弧氧化及硬质阳极氧化对 7050 铝合金表面氧化膜层的影响 [J]. 材料保护 , 2020, 53(6): 83-87.
[16] 唐海鹏 , 卞达 , 赵永武 , 等 . 二硫化钼改性石墨基复合减摩涂层的摩擦磨损特性 [J]. 塑料工业 , 2019, 47(12): 142-145.
[17] 程昱琳 , 张卿和 , 程英亮 , 等 . 钽在磷酸盐中等离子体电解氧化涂层耐腐蚀性能研究 [J]. 表面技术 , 2021, 50(6): 32-40.
[18] 朱彭舟 , 麻彦龙 , 蒋璐瑶 , 等 . 电解液成分对 7075 铝合金酒石酸 - 硫酸阳极氧化膜结构及性能的影响 [J]. 重庆理工大学学报 : 自然科学 , 2020, 34(1): 148-155.
[19] 何琼 . 酒石酸阳极氧化及封闭对建筑铝合金耐蚀性能的影响 [J]. 电镀与精饰 , 2021, 43(9): 19-24.
[20] Deyab M A, Essehli R, Bali B E, et al. Fabrication and evaluation of Rb 2 Co(H 2 P 2 O 7 ) 2 ·2H 2 O/waterborne polyurethane nanocomposite coating for corrosion protection aspects[J]. RSC Advances, 2017, 7(87): 55074-55080.
[21] Mani S P, Agilan P, Kalaiarasan M, et al. Effect of multilayer CrN/CrAlN coating on the corrosion and contact resistance behavior of 316L SS bipolar plate for high temperature proton exchange membrane fuel cell[J]. Journal of Materials Science & Technology, 2022 (2): 134-146.
[22] 曾纪勇 , 郭兴伍 , 郭嘉成 , 等 . 镁合金表面新型高耐蚀性植酸化学转化膜的制备 [J]. 表面技术 , 2019, 48(10): 230-237.
相似文献/References:
[1]张境洁*,李云红.建筑铝材表面处理及其性能研究[J].电镀与精饰,2021,(12):12.[doi:10.3969/j.issn.1001-3849.2021.12.003]
ZHANG Jingjie,LI Yunhong.Surface Treatment of Construction Aluminum and Its Performance[J].Plating & Finishing,2021,(9):12.[doi:10.3969/j.issn.1001-3849.2021.12.003]
[2]刘 静,马小昭,王帅星.绝缘保护用铬酸阳极氧化工艺研究[J].电镀与精饰,2022,(6):41.[doi:10.3969/j.issn.1001-3849.2022.06.009]
LIU Jing,MA Xiaozhao,WANG Shuaixing.Research on Chromic Acid Anodizing Technique for Insulation Protection[J].Plating & Finishing,2022,(9):41.[doi:10.3969/j.issn.1001-3849.2022.06.009]
[3]黄 锋,李智勇,宋 超,等.内腔零件硬质阳极氧化仿真及优化[J].电镀与精饰,2024,(8):60.[doi:10.3969/j.issn.1001-3849.2024.08.009]
Huang Feng Li Zhiyong Song Chao Li Wen Liu Zhijin Xiao Wei Qin Jinjun *.Simulation and optimization of hard anodic oxidation of internal cavity parts[J].Plating & Finishing,2024,(9):60.[doi:10.3969/j.issn.1001-3849.2024.08.009]
备注/Memo
收稿日期： 2022-07-16 修回日期： 2022-07-28 * 通信作者： 冀浩非（ 1983 ―），硕士，讲师，主要研究方向：机械材料、表面工程技术等， email ： Vocational_jz030@163.com 基金项目： 山西省高校科技创新项目（ 2020L0579 ）?/html>