LI Pengfei*,ZHANG Haitao.李鹏飞*，张海涛[J].Plating & Finishing,2021,(3):10-14.[doi:10.3969/j.issn.1001-3849.2021.03.003]
PTFE浓度对电厂冷却水管Ni-Mo-PPTFE复合镀层形貌和防垢性能的影响
- Title:
- 李鹏飞*，张海涛
- 关键词:
- 形貌; 防垢性能; Ni-Mo-P/PTFE复合镀层; PTFE浓度
- 文献标志码:
- A
- 摘要:
- 采用单因素实验法研究PTFE浓度对电厂冷却水管常用的20#钢表面Ni-Mo-P/PTFE镀层的形貌和防垢性能的影响。结果表明，不同PTFE浓度下复合镀层的形貌特征既存在相似之处也存在差异。在5~20 mL/L的范围内随着PTFE浓度增加，复合镀层平整度提高，生垢速率减小，主要归因于复合镀层中PTFE质量分数逐渐升高。但当PTFE浓度超过20 mL/L，随着PTFE浓度继续增加，复合镀层平整度和防垢性能有所下降。PTFE浓度为20 mL/L时，该复合镀层表面较为平整，PTFE质量分数达到3.19%，具有相对较好的防垢性能。
- Abstract:
- The influence of PTFE concentration on the morphology and anti-fouling property of Ni-Mo-P/PTFE coating on surface of 20# steel commonly used in power plant cooling water pipe was studied by single factor experiment. The results showed that there were similarities as well as differences between the morphology characteristics of composite coatings under different PTFE concentration. With the increase of PTFE concentration in the range of 5-20 mL/L, the flatness of composite coatings increased and the fouling rate decreased, which was mainly due to the increase of mass fraction of PTFE in composite coatings. However, when the concentration of PTFE exceeded 20 mL/L, the flatness and anti-fouling property of the composite coatings decreased with the increase of PTFE concentration. When the concentration of PTFE is 20 mL/L, the surface of the composite coating is relatively smooth, and the PTFE mass fraction reaches 3.19%, which has relatively good anti-fouling performance.
参考文献/References:
[1] 徐文芳, 梁平, 张云霞. 热处理对Ni-P化学镀层阻垢和耐蚀性能的影响[J]. 腐蚀科学与防护技术, 2015, 27(4): 349-352.
Xu W F, Liang P, Zhang Y X. Effect of heat treatment on anti-fouling performance and corrosion resistance of Ni-P electroless plated coating[J]. Corrosion Science and Protection Technology, 2015, 27(4): 349-352(in Chinese).
[2] Xu Z M, Jiang X, Liu Z D, et al. Experimental investigation of microbial fouling and heat mass transfer characteristics on Ni-P modified surface of heat exchanger[J]. Journal of Thermal Science, 2020, 19: 1-8.
[3] Lu R, Chen Y H, Yang J Y, et al. Study on heat transfer performance and anti-fouling mechanism of ternary Ni-W-P coating[J]. Applied Sciences, 2020, 10(11): 3905-3925.
[4] 何旭, 付传起, 王宙, 等. 稀土铈对化学镀复合镀Ni-P-PTFE镀层耐蚀性能的影响[J]. 表面技术, 2013, 42(2): 23-25.
He X, Fu C Q, Wang Z, et al. Effect of cerium concentration on the anticorrosive property of electroless Ni-P-PTFE composite coating[J]. Surface Technology, 2013, 42(2): 23-25(in Chinese).
[5] 陈衡阳. Ni-Cu-P-PTFE防垢镀层制备及性能研究[D]. 徐州: 中国矿业大学, 2014.
[6] 陈帅帅. 换热面Ni-W-P-PTFE防垢镀层制备及性能研究[D]. 徐州: 中国矿业大学, 2015.
[7] 杨梓健, 付传起, 王宙, 等. 稀土铈对Ni-Mo-P-PTFE镀层组织结构与防垢性能的影响研究[J]. 表面技术, 2019, 48(2): 89-93.
Yang Z J, Fu C Q, Wang Z, et al. Effect of cerium on microstructure and scale inhibition performance of Ni-Mo-P-PTFE coating[J]. Surface Technology, 2019, 48(2): 89-93(in Chinese).
[8] 董帅峰, 李伟, 刘平, 等. Ni-P过渡层沉积时间和PTFE浓度对Ni-P-PTFE复合镀层的影响[J]. 中国有色金属学报, 2018, 28(3): 579-585.
Dong S F, Li W, Liu P, et al. Effects of Ni-P deposition time and PTFE concentration on Ni-P-PTFE composite coatings[J]. The Chinese Journal of Nonferrous Metals, 2018, 28(3): 579-585(in Chinese).
[9] 王永真, 陈颖, 何凯龙, 等. 铜基Ni-P-PTFE化学复合镀层的阻垢和导热综合性能的研究[J]. 制冷学报, 2014, 35(1): 20-24.
Wang Y Z, Chen Y, He K L, et al. Investigation on anti-fouling capacity and thermal conductivity of Ni-P-PTFE composite coating[J]. Journal of Refrigeration, 2014, 35(1): 20-24(in Chinese).
[10] Laura P, Virgilio G, Giovanni P, et al. Synthesis and characterization of electroless Ni-P alloys for anti-wear and anti-fouling coatings[J]. Journal of Applied Biomaterials & Functional Materials, 2016, 330(2): 329-340.
[11] Cai Y W, Li S, Cheng Z L, et al. Facile fabrication of super-hydrophobic FAS modified electroless Ni-P coating meshes for rapid water-oil separation[J]. Colloids and Surfaces A: Physicochemical and Engineering Aspects, 2018(540): 224-232.
[12] 何凯龙, 陈颖, 冯婧, 等. Ni-P-PTFE化学复合镀层的导热及阻垢性能研究[J]. 材料导报, 2013, 27(2): 121-124.
He K L, Chen Y, Feng J, et al. Investigation on the thermal conductivity and anti-fouling property of Ni-P-PTFE electroless composite coating[J]. Materials Review, 2013, 27(2): 121-124(in Chinese).
相似文献/References:
[1]王 波*,赵东宏,许晓东.超声波辅助锌-锰系磷化处理对45钢法兰形貌与耐腐蚀性能的影响[J].电镀与精饰,2020,(7):7.[doi:10.3969/j.issn.1001-3849.2020.07.0020]
WANG Bo*,ZHAO Donghong,XU Xiaodong.Effect of Ultrasonic-Assisted Zinc-Manganese Phosphating Treatment on Morphology and Corrosion Resistance of 45 Steel Flange[J].Plating & Finishing,2020,(3):7.[doi:10.3969/j.issn.1001-3849.2020.07.0020]
[2]李鹏飞*,颜武岳.电厂冷却水管化学镀Ni-Co-P/PTFE复合镀层及其防垢耐蚀性能[J].电镀与精饰,2021,(1):18.[doi:10.3969/j.issn.1001-3849.2021.01.0040]
LI Pengfei*,YAN Wuyue.Electroless Plating of Ni-Co-P/PTFE Composite Coating on Power Plant Cooling Water Pipe and Its Anti-fouling Performance and Corrosion Resistance[J].Plating & Finishing,2021,(3):18.[doi:10.3969/j.issn.1001-3849.2021.01.0040]
[3]师 辉*,王树臣.稀土硝酸铈对油管锌钙系磷化膜形貌和性能的影响[J].电镀与精饰,2021,(2):22.[doi:10.3969/j.issn.1001-3849.2021.02.0050]
SHI Hui*,WANG Shuchen.师 辉1*，王树臣2[J].Plating & Finishing,2021,(3):22.[doi:10.3969/j.issn.1001-3849.2021.02.0050]
[4]周艳丽*.5052铝合金草酸阳极氧化和铬酸阳极氧化工艺研究[J].电镀与精饰,2021,(2):34.[doi:10.3969/j.issn.1001-3849.2021.02.0070]
ZHOU Yanli*.周艳丽*[J].Plating & Finishing,2021,(3):34.[doi:10.3969/j.issn.1001-3849.2021.02.0070]
[5]白玉伟*,陈锐.封闭处理对工程车用件磷化膜形貌和耐蚀性的影响[J].电镀与精饰,2021,(3):1.[doi:10.3969/j.issn.1001-3849.2021.03.001]
BAI Yuwei*,CHEN Rui.白玉伟*，陈锐[J].Plating & Finishing,2021,(3):1.[doi:10.3969/j.issn.1001-3849.2021.03.001]
[6]李向果*,姚国佳,马 勇,等.表面活性剂对微米银粉的粒径与形貌的影响研究[J].电镀与精饰,2022,(5):50.[doi:10.3969/j.issn.1001-3849.2022.05.009]
LI Xiangguo*,YAO Guojia,MA Yong,et al.Effect of Surfactant on Particle Size and Morphology of Micron Silver Powder[J].Plating & Finishing,2022,(3):50.[doi:10.3969/j.issn.1001-3849.2022.05.009]
[7]张静*,张茜,刘淑影,等.双拉变形对热浸镀铝硅镀层板腐蚀性能的影响[J].电镀与精饰,2022,(8):31.[doi:10.3969/j.issn.1001-3849.2022.08.006]
ZHANG Jing*,ZHANG Xi,LIU Shuying,et al.The Effect of Biaxial Stretching on Corrosion Performance of Hot-Dipped Al-Si Coated Material?/html>[J].Plating & Finishing,2022,(3):31.[doi:10.3969/j.issn.1001-3849.2022.08.006]
[8]袁 静*,袁 瑞,冯 涛,等. 镀液中金属离子浓度比对化学镀Ni-Co-P薄膜的形貌及 磁性能的影响 [J].电镀与精饰,2023,(2):7.[doi:10.3969/j.issn.1001-3849.2023.02.002]
Yuan Jing? Yuan Rui,Feng Tao,Mao Duolu.Influence of metal salt concentration ratio in plating bath on the morphology and magnetic properties of electroless Ni-Co-P film[J].Plating & Finishing,2023,(3):7.[doi:10.3969/j.issn.1001-3849.2023.02.002]
[9]孙伟*,杨辉,徐秀凤,等.促进剂对建筑结构钢锌钙系磷化膜形貌和耐蚀性的影响[J].电镀与精饰,2023,(4):8.[doi:10.3969/j.issn.1001-3849.2023.04.002]
Sun Wei*,Yang Hui,Xu Xiufeng,et al.Effects of accelerating agents on morphology and corrosion resistance of zinc-calcium phosphating films on building structural steel[J].Plating & Finishing,2023,(3):8.[doi:10.3969/j.issn.1001-3849.2023.04.002]
[10]卿启新*,黄炎光,王 晨,等.氯离子在局部电化学中对铜电沉积的影响[J].电镀与精饰,2024,(7):91.[doi:10.3969/j.issn.1001-3849.2024.07.014]
Qing Qixin*,Huang Yanguang,Wang Chen,et al.Effect of chloride ions on copper electrodeposition in local electrochemistry[J].Plating & Finishing,2024,(3):91.[doi:10.3969/j.issn.1001-3849.2024.07.014]
备注/Memo
收稿日期： 2020-08-09；修回日期： 2020-09-12
通信作者： 李鹏飞，teacher_li801@163.com
基金项目： 内蒙古自治区教育厅项目（NJZY18273）